Plain bearings. Tolerances - Tolerances on form and position and surface roughness for shafts and thrust collars Ingestion-build-63114 This document applies to air

This document applies to air transfer devices of the following types:

This Part of this European Standard sets out minimum requirements for the specific types of water to reduce the risk of corrosion

Aims and tolerances should be developed through use-case analysis

BS EN 12953 specifies requirements for inspection during and after construction

Plain bearings. Tolerances - Tolerances on form and position and surface roughness for shafts and thrust collars Ingestion-build-63114 This document applies to airWhat is this standard about? This document specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. It is applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically. This document is not applicable to crankshaft bearing units in combustion engines.