1-1/2" Tappered Pull Connector Compression Points It requires a very shallow

It requires a very shallow and short entrance trench approx 6 Inches deep and 24 to 30 inches long depending on the angle

worn steel bit and cut off the end so that it will be blunt

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

One larger hole that will slide over the impact cap and one smaller hole that will recieve the sawed off blunted

1-1/2" Tappered Pull Connector Compression Points It requires a very shallowThis connector is used to connect 1 1 2" poly pipe to the shafts before the shafts are extracted from the ground. This pull connector will make a secure and strong connection to any 1 1 2" rolled Polyethylene conduit for fiber optic Poly pipe for water lines or Polyethylene pipe for gas lines Etc (One size fits all types) It has a swivel between the two ends with lateral wobble. This unique design combination allows for the female threaded end of the